No results were found for the filter!
These CNC machined aluminum turn signal adapters allow the mounting of almost all accessory turn signals with M8 thread on the original turn signal holder of all watercooled Triumph models. The shape of the turn signal holder fits...
A pair of CNC machined standpipe clamps for attaching turn signals to the front of the fork. Select the motorcycle model you want! The clamps can easily be attached to the fork tubes within a few minutes. At the included turn signal...
Universal turn signal holder for mounting the indicators at the rear of the license plate. The holder is 17.5cm wide. Holes for mounting on the license plate must be drilled so that it can be installed individually by the customer at his...
Rizoma turn signal holder for mounting the turn signals on the fork. The clamps are made of very high quality black plastic. The material is very flexible, which makes it possible to put the clamps easily over the fork without having to...
32mm turn signal arm extension for all Rizoma & Motogadget Pin turn signals. Perfect when the turn signals are too close together and do not respect the minimum distance required by law. Or you just want to have the turn signals a little...
A pair of turn signal holder in ripped design for mounting on the upper strut mount. Optionally in matt silver or polished. The brackets are supplied with a longer screw for mounting (mounting is done in 1-2 minutes, the strut does not...
LSL lamp holder with milled braces black Brackets and struts made of aluminum milled, black anodized. The front of the bracket is 116mm By the asymmetrical design of the struts, the lamp can be mounted differently high. Also available...
From €119.95 *
Black aluminum adapters for the original turn signal clamps on the fork. The adapters have an 8 hole (which is suitable for most turn signals on the accessory market like Rizoma, Kellermann etc.). Does NOT fit from our accessories to the...
Black aluminium adapters for the original turn signal holder of the LC-Triumph motorcycles. The adapters fit exactly for the drop indicators (see accessories in this description). Also suitable for other turn signals with M10 thread. For...
Blinkerhalter zur Verlegung der Blinker an die Innenseiter der Federbein aufnahme (Innenseite des Rahmens). Mit passenden Schrauben zur Befestigung der Halter. Die Halter sind Schwarz pulver beschichtet. Die optimale Verlegung um die...
Dresser Plates for accessory indicators. Cover the open holes at the Bonneville T100 & T120 Pair of METAL! In black, matching the lamp holders. Can be used to easily conceal the holes when the direction indicators are mounted in a...
Front flasher for Bonneville T100 & T120 + Street-Twin-Scrambler-Cup black coated. Attached to the front of the regulator. The original regulator can be screwed further in front of the holder.
Rear seatbelt kit. Easy installation on original threads under the seat. Pair in black coated. A suitable screw for fastening is included in the scope of supply.
The matching flasher in the set (4 pieces for a pair of turn signals) in order not to cut the original wiring harness. These plugs are crimped onto the cables of the turn signals and can then be easily and quickly plugged on the cable...
Needed when you install LED indicators and do not change the flashing relay. One set is enough for a pair of turn signals.
This cable set fits into the original wiring harness with the plug. The open cable ends only need to be connected with blinkers or rear lights from our program (soldering or crimping). Then just heat the shrink tube, heat it up with the...
Adapter cable to extend the original H4 headlight cable. Very handy if you need to put the wiring of the motorcycle under the tank.
The CAN-BUS universal resistor can be set to several different ohm numbers (see list below). Who does not know the problem that the flashing frequency does not fit anymore when converting to LED flashers? The problem hasn't become any...